Request a Quote
Fill out the form below to request a free estimate!
Write your message!

Asphalt Sealcoating - Champlin MN, Plymouth, Maple Grove, Eden Prairie, Minnetonka, Bloomington

Aurora Asphalt & Sealcoating offers the top of the line sealcoating service. Sealcoating is essential in preventing your asphalt surface from premature failure.

Our sealcoating process consists of 5 steps:

  1. POWER CLEANING: Wire brushes/brooms are used to loosen up all debris on the asphalt surface and in cracks. Power blowers with air speed of over 200mph are used then to blow the surface clean. Standard sweep equipment is used for large sealcoating projects.
  2. OIL SPOT PRIMING: Petroleum spots are cleaned and primed to improve adhesion of sealer.Asphalt Crack Filling - Champlin MN, Plymouth, Maple Grove, Eden Prairie, Minnetonka, Bloomington
  3. CRACK FILLING: Hot rubberized crack filler is used for filling cracks 1/4 to 1/2 inches wide. Rubberized crack filler is poured into cracks 1/2 to 1 -1/2 inches wide and 1/4 inch deep at an additional charge. The rubber will retain its elasticity during repeated freeze/thaw cycles.
  4. SEALCOATING: Our sealer is a commercial grade asphalt emulsion base sealer which meets and exceeds RP-355e specifications. The sealer is a slip-resistant formula with silica sand and rubber additives. This allows for maximum penetration into the pores of the surface. The sealer is applied with a 36 inch or 48 inch brush thus also providing maximum penetration versus spray applications. Finally, we barricade all access to the sealed surfaces.

Aurora 1 Year Warranty

Aurora Asphalt & Sealcoating will not be responsible for damage due to excessive standing gravel, snowplows, tire chains, winter salt application or sanding water. Warranty is limited to the sealer only and excludes cracks that may have reopened, petroleum damage, punctures, and normal wear.